Case-IH In-Frame Engine Overhaul Kit D282 CID Diesel. 6 Cyl. 1.125” wrist pin only, does not fit
0.875” wrist pin. Standard Bore: 3-11/16”, cupped head piston. Serial number is stamped on the left
hand side of the engine on pad below the oil pump shaft support. Kit Contains: Piston Liner Kit,
Connecting Rod Bearing, Upper Gasket Set, Pan Gasket. Fits models: 2656, 2706, 560, 660, and 706.
•
6 CYL DIESEL; 1.125 wrist pin
•
STD BORE: 3-11/16", CUPPED HEAD PISTON
•
S/N is Stamped on LH Side of Engine on pad Below the Oil Pump Shaft Support
•
Used with 1.125 wrist pin only. Does not fit .875 wrist pin.
Cross References:
Crossed From:
BIFH1174
TISCO
Fits the following makes and models:
Case-IH INDUSTRIAL/CONSTRUCTION: 2656 (ENG S/N <44821)
Case-IH INDUSTRIAL/CONSTRUCTION: 2706 (ENG S/N <44821)
Case-IH TRACTOR: 560 (ENG S/N <44821)
Case-IH TRACTOR: 560 (TR SN 29265-40698)
Case-IH TRACTOR: 560 (TR SN 6766-29264)
Case-IH TRACTOR: 656 (ENG S/N <44821)
Case-IH TRACTOR: 660 (ENG S/N <44821)
Case-IH TRACTOR: 660 (TR SN 29265-40698)
Case-IH TRACTOR: 660 (TR SN 4370-29264)
Case-IH TRACTOR: 706 (ENG S/N <44821)